Last Chance Archery Last Chance Limb Lock Kit

A bow slipping in the press is a mistake you only make once. Beyond parallel limbs demand more than a standard setup.

Some techs press and hope, while others lock the bow in and work.

Built for Beyond Parallel: The kit is designed specifically for pressing beyond parallel limb bows on an LCA press. The limb angle that worries other setups is the one this kit was made for.

A Safety on the Limbs: The Limb Locks are foam-covered rollers that hold the bow from slipping. You run the press down, and the bow stays where you put it.

Enclosed at Every Angle: The Limb Lock Fingers use a rotating head that keeps the limbs fully enclosed as you press. The angle changes through the press, and the hold does not.

No Marks Left Behind: Each finger is rubber coated to protect the limbs from scratches. The bow leaves your bench looking like it did when it arrived.

Adjusts to the Bow: All four fingers move in and out and forward and back, and the Limb Locks adjust by bow model. You match the limb angle, press the bow, and get to work on the string.

Press the hard bows the way careful techs do.